![]() ![]() If the Readiness code does not change to YES, check for any Pending codes in the Generic OBD II section of the Scan Tool. If it does, perform any additional driving under the conditions required to run the remainder of the monitors. Allow the engine to idle, but do not turn off the ignition key.Ĥ.Check the status of the Readiness code for the Catalyst Monitor. Bring the vehicle to a stop in a safe place. Then accelerate back to 50 mph for 5-10 minutes. Then decelerate back to idle speed for one minute. Bring up the Readiness Code for the Catalyst Monitor.Ģ.Start the engine and allow it to run at idle until the ECT PID is at least 158✯.ģ.Accelerate smoothly to 50 mph and maintain that speed for 10 minutes. Use the Scan Tool to clear any stored DTC's and to reset the Onboard Diagnostic Monitors.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |